Bar Stock
- We grind bar stock in all materials up to 20' in length and diameters ranging from .062-7".
- Grind to metric sizes / pitch diameter.
- Can hold close tolerance on full length of bar
- True polished finish to 8 rms
- As little as .0005 stock removal
- Pump Shaft Quality
Dowel Pins
- Tolerance as close as +/- .0001
- .052 to 2" diameter
- .500 to 8 inch length
- Annealed or hardened parts
Grind to Fit Bearing
- Custom grind to fit your bearing or holes
Grind to A Head
- Rough turned or blank stock ground to diameter at the length that you need
- No center holes required
Head Swell Grinding
- Bring typical .005 to .040 head swell back to size without changing body size
- Turn bolts into cap screws
- No center holes required
Multi-Dimensional
- Progressively smaller diameters ground in any diameter and length
- No center holes required
Morse Tapers
- Limited tapers ground from rough turn
- No center holes required
Cotter Pins
- Flats ground for small cotter pins
- Up to 8" length
- .001 tolerance over length of pin
Flats Ground for Manway Bolts & Pins
- .125 to .500 diameter
- Up to 8" length
Dog Points
- This part pictured started out as .500 all-thread rod ground dog point to .125 +/- .001 over 16" length
- .125 to 1" diameter
- .500 to any length you need